Introduction; Setup And User Guide; Product And Function Descriptions - Dantherm CDT 30 MKII Servicehandbuch

Product and function descriptions

Introduction

How it works
Illustration
Water container
2

Setup and user guide

This section provides a product description of the CDT30/40/60MKII, plus a description
of its functionality.
Air flow through the dehumidifier:
How the air changes as it passes
through the dehumidifier:
The fan draws humid air through a fil-
ter inside the dehumidifier.

The air is cooled, causing the moisture
content to condense into drops of wa-
ter, which are collected in the water
container.

The air is reheated using heat from the
dehumidifier operation (temperature
increase of approx. +5 °C).
As the air is repeatedly circulated through the dehumidifier, its moisture content is re-
peatedly reduced, resulting in rapid, gentle drying. The dehumidifier can run constantly,
or be controlled by a built-in hygrostat.
Illustration of dehumidifier:
Rear view
Condensed water is collected in the water container or it can be piped to a drain via a
hose nozzle (optional accessory).
The dehumidifier cuts out automatically when the container is full. See the user guide
for emptying the water container. The dehumidifier cannot operate when the container
is removed.
www.dantherm-ltd.ru • info@dantherm-ltd.ru • +7 (495) 545-48-79
Москва. Каширский проезд д. 19 стр. 2
Handle
Control
panel
Air intake with PPI
filter behind grille
Power cord
Air exhaust
Data socket
remote monitoring
Type plate behind water container
Water container
Wheel
Front view
Continued on next page