Automatic Switch-Off; Troubleshooting - Silvercrest SKBL 56 A1 Bedienungsanleitung

Automatic switch-off
If the 3.5-mm jack socket is not in use or their is no playback via Bluetooth
the speakers automatically switch off after about 10 minutes.
The operating/charging LED
Any existing Bluetooth connection will be terminated.
®
♦ Press and hold the
speaker back on.
NOTE
► The automatic switch-off function does not work while the speakers are
charging.

Troubleshooting

If you cannot pair the speakers to a compatible Bluetooth
proceed as follows:
♦ Make sure that the Bluetooth
device. When a device is connected via a 3.5-mm jack cable, the
function is deactivated.
Bluetooth ®
SKBL 56 A1
will go out and you will hear a beep.
button for about 4 seconds to turn a
music device,
®
® function is activated on the music
♦ Ensure that the speaker is switched on.
,
® ♦ If you use several music devices, ensure that any previous connection
is disconnected (see section Function of the buttons for music play-
back). There may be a previously paired device within range.
♦ Make sure that the speakers are no more than 10 metres from the
® device and each other. Make sure that there are no
Bluetooth
barriers or electronic devices placed between them.
Device does not switch on.
♦ The integrated battery is not charged.
Charge the battery (see section Charging the speaker).
No sound.
♦ The volume on the device or the playback device is set to minimum.
Increase the volume on the device or on the playback device.
♦ Playback has not been started on the playback device. Start playback
on the playback device.
GB│IE │ 31 ■