♦
Repeat the process with the second speaker. Wait a moment. If the speak-
ers do not automatically pair with each other, place one of the speakers
manually into pairing mode. To do this, hold down the
and the
button (
until you hear a higher-pitched beep. Wait a moment. As soon as the
two speakers automatically pair with each other, the operating/charging
LEDs
of both speakers light up blue. You will hear a beep.
♦
Select SKBL 56 A1 from the list of found devices on your Bluetooth
device to pair it to a speaker. You will hear a short beep when the connec-
tion has been successfully established. The operating/charging LED
on the connected speaker will also permanently light up orange. This
speaker will output the left stereo channel.
■
28
│
GB│IE
) of the affected speaker for about 2 seconds
NOTE
►
The next time you turn on the speakers, they will connect automatically
button
to each other. To unpair the speakers, proceed as follows.
►
If you want to connect the speaker to another Bluetooth
must first unpair the current Bluetooth
the
button and the
speaker for about 2 seconds until you hear a beep. Alternatively, you
®
can terminate the connection on your Bluetooth
case, you will also hear a beep.
device, you
®
®
device. To do this, hold down
button (
) of the affected
device. In this
®
SKBL 56 A1