Operating The Speakers In Mono Mode - Silvercrest SKBL 56 A1 Bedienungsanleitung

♦ Press and hold the
speaker off and deactivate the Bluetooth
beep. The operating/charging LED
NOTE
► If the two speakers are coupled with each other via Bluetooth
both speakers will switch off as soon as you switch off one speaker.

Operating the speakers in mono mode

When supplied, the speakers are preset in mono mode by default. This means
you can pair each speaker with a one playback device. Before you can use
the speakers, you must pair them with a compatible Bluetooth
♦ Make sure that the speakers are switched off and the Bluetooth
device is switched on.
♦ Set the Bluetooth device so that it scans for other Bluetooth
®
devices. A detailed description of how to do this can be found in the
operating instructions for your Bluetooth
■ 26 │ GB│IE
button for about 2 seconds to turn one
® function. You will hear a
will go out.
device.
®
® device.
♦ Press and hold the
speaker on and activate the Bluetooth
and the operating/charging LED
NOTE
, then ► Make sure that the speakers are no more than 10 metres from the
®
® device and each other. Make sure that there are no
Bluetooth
barriers or electronic devices placed between them.
♦ Select SKBL 56 A1 from the list of found devices on your Bluetooth
device to pair the two devices. You will hear a short beep when the
connection has been successfully established. The operating/charging
LED flashes twice every 3 seconds.
®
♦ If you want to operate the second speaker in mono mode with a different
playback device, carry out the process described above
®
Bluetooth
with the second speaker. Make sure you do not switch on the second
®
speaker until you have paired the first speaker with a Bluetooth
playback device.
button for about 2 seconds to turn a
® function. You will hear a beep
flashes alternatively orange and blue.
SKBL 56 A1
®
®