Measuring Blood Pressure - Beurer BC 40 Gebrauchsanweisung

Time
The hours flash on the display.
• Select the desired hour using the memory but-
ton M and confirm with the START/STOP but-
ton .
The minutes flash on the display.
• Select the desired minute using the memory
button M and confirm with the START/STOP
button .
Once all the data has been set, the device switches off
automatically.

5. Measuring blood pressure

Ensure the device is at room temperature before measur-
ing. The measurement can be performed on the left or right
wrist.
Attaching the cuff
1 2 3
24
• Expose your wrist. Ensure that the circulation of the arm
is not hindered by tight clothing or similar. Place the cuff
on the inside of your wrist.
• Fasten the cuff with the hook and loop fastener so that
the upper edge of the monitor is positioned approx. 1 cm
below the ball of your thumb.
• The cuff must be fitted tightly around the wrist, but must
not constrict.
Blood pressure may vary between the right and left wrist,
which may mean that the measured blood pressure values are
different. Always perform the measurement on the same wrist.
If the values between the two wrists are significantly different,
please consult your doctor to determine which wrist should
be used for the measurement.
Important: The unit may only be operated with the origi-
nal cuff.
Adopt the correct posture
• Before every measurement, relax for about five minutes.
Otherwise deviations can occur.
• You can take the measurement while
sitting or lying. To take your blood
pressure, make sure you are sitting
comfortably with your arms and back
leaning on something. Do not cross
your legs. Place your feet flat on the
• • • • • • • • • • • • •