Error Messages/Troubleshooting - Beurer BC 40 Gebrauchsanweisung

• Press the memory button M.
AM flashes on the display.
The average value of the morning measure-
ments for the last 7 days is displayed (morning:
5.00 a.m. – 9.00 a.m.).
• Press the memory button M.
PM flashes on the display.
The average value of the evening measurements
for the last 7 days is displayed (evening: 6.00
p.m. – 8.00 p.m.).
Displaying individual measurements
• When the memory button M is pressed again,
the last individual measurement is displayed.
• When the memory button M is pressed again,
you can view your individual measurements.
• To switch the device off again, press the
START/STOP button
You can exit the menu at any time by pressing the
START/STOP button
Deleting measurements
Deleting individual measurements
• Start individual measurement access.
• Press and hold the memory button M for approx. 5 sec-
onds. The relevant measurement is deleted.
.
.
• The display starts to flash, then an empty display with
empty user memory frame is displayed. Press the memory
button M to delete additional values or press the START/
STOP button to switch off the device.
Deleting all measurements
• Start access to average value of all saved measurements
by pressing the memory button M twice.
• Press and hold the memory button M for approx. 5 sec-
onds. All measurements are deleted.
• The display starts to flash, then an empty display with
empty user memory frame is displayed. Press the memory
button M to delete additional values or press the START/
STOP button to switch off the device.

8. Error messages/troubleshooting

In the event of errors, the error message
display.
Error messages may appear if:
• you move or speak during the measurement (
on the display)
• the cuff is placed on the arm too tightly or loosely or if the
cuff is damaged (
• the pump pressure is higher than 290 mmHg (
appears on the display)
• the batteries are almost worn out (
27
_ appears on the
appears on the display)
and ).
appears