Storage; Washing And Cleaning The Machine; Disposing Of Packaging And The Machine After Service Life; Directions For Ordering Replacement Parts - Vari Hurricane F-550 Bedienungsanleitung

Problem
Engine won't start
Brake does not work
Machine cannot be stopped
Work tool cannot be stopped
Control levers do not return
Other defect
Table 8: Problems and troubleshooting

2.5.8 Storage

When storing for extended periods (e.g. after a season), clean the machine from all impurities and plant remnants. Prevent access of
unauthorized persons to the machine. Protect the machine against weather influences, but do not use air-tight protection due to increased
corrosion.

We recommend that you have the machine prepared for the upcoming season in one of the authorized service centres.
The service network is fully busy before the season.
We recommend, in particular:

To preserve worn places on the work tool.

Remove dirt, dust, and plant remains from the machine.

Repair damaged areas on painted parts.

Drain the gasoline from the fuel tank and the carburettor (additional instructions included in the engine operating
manual).

Lubricate the machine as recommended in Table 6 .

Check the tyre pressure and inflate the tyres

2.5.8.1 Washing and cleaning the machine

When cleaning and washing the machine, follow all valid provisions and laws for protecting streams and other water resources from
pollution or contamination by chemicals.

Never wash the engine using a stream of water! The engine electrical equipment could be damaged when starting.

Do not use a high pressure washer!

2.5.9 Disposing of packaging and the machine after service life


After unpacking the machine, you are obligated to dispose of packaging according to national laws and waste handling
regulations.
We recommend that you follow the procedure below when disposing of the machine after the service life has been reached:
1) Disassemble all of the parts from the machine that can be reused.
2) Drain the engine and gearbox oil into a suitable closed container and submit to the waste collection site
3) Remove parts made from plastic and non-ferrous metals.
4) Dispose of the disassembled remainder of the machine and parts according to national laws and waste disposal regulations.

2.5.10 Directions for ordering replacement parts

This manual does not include a list of replacement parts.
To properly identify your machine, you must know your Model (Type), serial number (№), and order number (C№) specified on the
index plate, the box, or on the warranty card. Only after knowing this information will you be ensured of receiving the correct replacement
part from your retailer.
73 The repository location is provided by respective local authorities.
Cause
No gasoline in the tank
Fuel supply is closed
Other defect
No axial clearance in cable, the cable is tight
The brake cam is stiff
Lining is worn – brake cannot be adjusted
The tensioner does not return
The wire in the Bowden cable is stiff, Bowden cable bent
The tensioner does not return
The wire in the Bowden cable is stiff, Bowden cable bent
Broken return spring
Other defect
Solution
Fill the tank with gasoline
Open the fuel supply
Contact the service centre
Adjust the brake
Lubricate the cam
Contact the service centre
Lubricate
Lubricate or replace Bowden cable, as necessary
Lubricate
Lubricate or replace Bowden cable, as necessary
Replace with new spring
Contact the service centre
Contact the service centre
toMAX pressure.
F-550
73 .
29