Maintenance - STIEBEL ELTRON DCE 11/13 Bedienung Und Installation

INSTALLATION

Maintenance

Registering / deregistering the wireless remote control at the
DCE 11/13 RC
1 Button for registering and deregistering
2 Yellow LED illuminates when wireless remote control is
activated
f To start registration of the wireless remote control briefly f
press the button. The yellow LED starts to flash. Now press
key "1" on the wireless remote control. A brief flashing of the
LED indicates that registration was successful. The yellow LED
then extinguishes.
f To deregister the wireless remote control press the key for f
5 seconds. A brief flashing of the LED indicates that deregis-
tration was successful. The yellow LED then extinguishes.
Plug-in position of the wireless remote control for
DCE 11/13 RC
30 |DCE 11/13| DCE 11/13 RC| DCE 11/13 H
15. Maintenance
1
Draining the appliance
2
For maintenance work or when there is a risk of frost, drain the
appliance as follows:
f Close the shut-off valve in the cold water inlet pipe. f
f Open the draw-off valve. f
f Undo the water connections on the appliance. f
f Remove the appliance. f
f Drain the appliance via the water connections (residual water f
will remain in the appliance).
Appliance storage
f Store the dismantled appliance in a room free from the risk f
of frost, as water residues remaining inside the appliance can
freeze and cause damage.
Cleaning or replacing the strainer/flow limiter
DCE 11/13
DCE 11/13 RC
DCE 11/13 H
1 Strainer
2 Flow limiter
WARNING Electrocution
Before any work on the appliance, disconnect it omnip-
olar from the power supply.
WARNING Burns
Hot water may escape during draining.
www.stiebel-eltron.com
1
2
2
1