Test Symbols; Appliance Description; Settings; Dce 11/13 | Dce 11/13 H - STIEBEL ELTRON DCE 11/13 Bedienung Und Installation

OPERATION

Appliance description

2.3

Test symbols

See type plate on the appliance.
3. Appliance description
The electronically controlled compact instantaneous water heater
maintains a constant outlet temperature up to its output limit,
irrespective of the inlet temperature.
The appliance warms the water directly at the draw-off point, as
soon as you turn on the hot water tap. The short pipe runs ensure
that energy and water losses are minimal.
For the start flow rate, see "Installation / Specification / Data
table".
The DHW output depends on the cold water temperature, the
heating output, the flow rate and the set temperature required.
DHW temperature
The DHW outlet temperature can be variably adjusted.
Heating system
The bare wire heating system is suitable for hard and soft water
areas. This heating system has a low susceptibility to scale build-
up. The heating system ensures quick and efficient DHW provision.
Note
The appliance is equipped with an air detector that large-
ly prevents damage to the heating system. If, during op-
eration, air is drawn into the appliance, the heater shuts
down automatically for one minute, thereby protecting
the heating system.
4.

Settings

4.1 DCE 11/13 | DCE 11/13 H
Operation
30
20
1
1 Temperature selector: Temperature setting range
20 °C – 60 °C
4.2

DCE 11/13 RC

With the wireless remote control, the temperature setting can
be adjusted by wireless control. The selected temperature is dis-
played on the remote control.
22 |DCE 11/13| DCE 11/13 RC| DCE 11/13 H
°C
40
50
60
The wireless remote control provided is registered to the receiver
module. Only a registered remote control can alter the settings
on the appliance.
The wireless range is reduced by obstacles between the appliance
and the remote control.
You can mount the wireless remote control anywhere using the
wall mounting bracket supplied in the standard delivery.
Operation
1
1 Display
2 Temperature selection 20 °C – 60 °C in 0.5 °C steps, using the
+ and - buttons
3 Memory keys 1 and 2
The wireless remote control is normally in power save mode,
which means the display is switched off. Pressing any key activates
the wireless remote control, the temperature display appears. The
progress bar indicates that data is being transmitted to the device.
If no key is pressed within 10 seconds the wireless remote control
automatically switches back to power save mode.
The selected temperature is also maintained in power save mode.
Saving temperature to memory keys
f Select the required temperature. f
f Press memory key 1 or 2 for 2 seconds. The temperature dis- f
play flashes once to confirm.
f The heater of the appliance can be switched off (display f
message OFF). To switch the heater off, select the minimum
temperature (20 °C), then press the "-" button once.
Battery change
1
1 Battery change symbol
When the battery symbol illuminates, change the battery of the
wireless remote control. A change of battery may also become
1
2
+
3
2
-
1
+
2
-
www.stiebel-eltron.com