Safety; Intended Use; General Safety Instructions; Test Symbols - STIEBEL ELTRON DHF 13 C Bedienung Und Installation

OPERATION

Safety

2. Safety
2.1

Intended use

This appliance is intended for domestic use. It can be used safely
by untrained persons. The appliance can also be used in a non-do-
mestic environment, e.g. in a small business, as long as it is used
in the same way.
This pressure appliance is designed to heat DHW. The appliance
can supply one or more draw-off points.
Any other use beyond that described shall be deemed inappropri-
ate. Observation of these instructions and of instructions for any
accessories used is also part of the correct use of this appliance.
2.2

General safety instructions

CAUTION Burns
During operation, the tap can reach temperatures in ex-
cess of 60 °C.
There is a risk of scalding at outlet temperatures in ex-
cess of 43 °C.
WARNING Injury
!
The appliance may be used by children aged 8 and up and
persons with reduced physical, sensory or mental capa-
bilities or a lack of experience and know-how, provided
that they are supervised or they have been instructed on
how to use the appliance safely and have understood
the resulting risks. Children must never play with the
appliance. Children must never clean the appliance or
perform user maintenance unless they are supervised.
Material losses
!
Protect the appliance and its tap against frost.
20 |DHF-C
2.3

Test symbols

See type plate on the appliance.
Country-specific approvals and certifications: Germany
A general test certificate as verification of suitability regarding
noise emissions has been issued for this appliance, based on the
State Building Regulations [Germany].
DIN 4109
PA-IX 7855/I
3.

Appliance description

The hydraulically controlled instantaneous water heater heats
water as it flows through the appliance. When a tap is opened,
the appliance starts heating automatically at the selected output as
soon as the start-up volume is exceeded (see chapter "Installation /
Specification / Data table"). You can adjust the hot water volume
and temperature at the tap by mixing in cold water.
You can choose between 2 output stages. In addition, 2 output
stages are hydraulically controlled in relation to the flow rate.
The flow meter compensates for pressure fluctuations. The flow
meter ensures largely stable temperatures. The control unit limits
the flow rate, thereby ensuring an adequate increase in the DHW
temperature at all times.
Heating system
The tubular heater heating system has a pressure-tested copper
cylinder. The heating system is suitable for soft water areas (for
application range, see chapter "Installation / Specification / Data
table").
www.stiebel-eltron.com