Assembly; Setting Up; Mount The Sharpener; Operation - Parkside PSS 65 A1 Originalbetriebsanleitung

Assembly

Caution! Risk of injury!
- Ensure that you have sufficient
space in which to work, and that
you do not endanger other people.
- All covers and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug before
changing the setting on the de-
vice.

Setting up

Place the sharpening station on firm surface
and fasten the device. Ideally, bolt the drill
to the surface. Use the mounting holes for
the work bench assembly (
baseplate for this.
The screws and nuts required for as-
sembly are not part of the scope of
delivery.

Mount the sharpener

1. Select one of the three sharpeners.
2. In order to remove a sharpener
from the working position, you
must press down the release lever
for the sharpener (
3. Remove the sharpener from the
guide rails, upwards.
4. In the storage positions, the sharp-
eners are not fixed to the right
and left side and can be easily
removed from the guide rails.
5. In order to fasten the selected
sharpener in the working posi-
tion, from above push this into the
guide rails. Press the sharpener
down until it snaps into place.

Operation

9) in the

Switching on and off

13).
1. To switch on, press the "I" On switch
2. To switch off, press the "0" off switch
The sharpeners also present
a safety device. Never use
this device without a sharp-
ener. Risk of injury!
Caution! Risk of injury!
- Always disconnect the plug from
the mains socket before working.
- Use only grinding disks and acces-
sories recommended by the manu-
facturer. The use of other insertion
tools and other accessories may
cause risk of injury.
- Never operate the device without
the visual protection disk.
- Switch on the equipment only
when it is safely installed on the
work surface.
Despite spark protection, al-
ways wear safety goggles
while working in order to
avoid eye injuries.
Keep your hands away from
the grinding disc and grind-
ing belt when the device is in
operation. Injury hazard!.
Ensure that the mains voltage
matches the specifications on the
rating plate.
Connect the equipment to the mains.
and the device starts up (see
and the device switches off (see
GB MT
3).
3).
55