Commissioning / Operation; Recommended Test Settings - Siemens 5TC1 Series Bedien-Und Montageanleitung

Fig. 21
Fig. 22
66

6. Commissioning / operation

6.1 Recommended test settings

To test the functioning and detection performance of the motion
detector attachment ' Komfort' after the installation, the device
should have the following settings (settings of the device on
delivery):
1. Select the automatic mode by setting switch (4) to center
position (Fig. 21).
2. Turn the brightness control (2) to daylight operation (end
position 'Sun') (Fig. 22).
3. Turn the OFF-delay control (1) to approx. 10 seconds
(Fig. 22).
4. Turn the sensitivity control (3) to maximum sensitivity
(Fig. 22).
Select the individually desired settings after testing.