Settings; Off-Delay - Siemens 5TC1 Series Bedien-Und Montageanleitung

Fig. 15
Fig. 16
50

5. Settings

The OFF-delay (1), the sensitivity (2) and the brightness (3)
can be set by means of three potentiometers. These are
located at the rear of the motion detector attachment 'Kom-
fort '. (Fig. 15)

5.1 OFF-delay

The OFF-delay determines how long the lamps remain on
after detection of the last movement. The delay can be set
within a range of approx. 10 seconds to approx. 30 minutes.
The setting is non-linear, i.e. longer time spans can only be
selected within a relatively coarse grid.
To change the OFF-delay, turn control (1) in the desired
direction (Fig. 16).
When the motion detector attachment 'Komfort ' is active, each
movement detected thereafter will retrigger the OFF-delay.
This means that the OFF-delay starts all over again.
The motion detector attachment 'Komfort ' has no forced shutoff
function. This means that permanent movements inside the
detection field causes the lighting to be continuously on.