Activating The Teach Mode - Siemens 5TC1 Series Bedien-Und Montageanleitung

Fig. 19
62

5.5 Activating the teach mode

1. To activate the teach mode, cover up the motion detector
attachment 'Komfort' completely at least three times for a
short moment (approx. 1 s) during the next 9 seconds
(Fig. 19).
2. The teach mode is active when the motion detector
attachment 'Komfort' has detected three brightness changes.
3. When the lighting was on at the time of activation, the
activation is confirmed by the lamp being turned off and then
on again for three seconds. When the lighting was off at the
time of activation, the lamp will be turned on for 3 seconds.
4. During the next minute, step back from the motion detector
attachment ' Komfort' to allow for correct measurement and
storage of the actual brightness level.
5. Storage is confirmed by by the lamp being turned on for 3
seconds.
6. The motion detector attachment 'Komfort' switches back to
the preset mode of operation.