Modes Of Operation; Continuously Off; Automatic Operation; Continuously On - Siemens 5TC1 Series Bedien-Und Montageanleitung

Fig. 13
Fig. 14
48

4. Modes of operation

The motion detector attachment 'Komfort ' can be operated in
three different modes by setting the switch to the desired
position.
The switch can be locked in the automatic operation position
with a locking clip (Fig. 13).
1. Set the device to the automatic mode
2. Remove the slider (1) carefully with a screwdriver (2)
3. Insert the locking clip
4.1 Continuously OFF (Fig. 14, A)
The lighting is switched off permanently.
Switching from extension units is not possible.
4.2 Automatic operation (Fig. 14, B)
The motion detector attachment 'Komfort ' switches on dependent
on brightness when movements are detected and off after the
preset OFF-delay when no movements are detected anymore.
Switching from extension units is possible.
4.3 Continuously ON (Fig. 14, C)
The lighting is switched on permanently.
Switching from extension units is not possible.