Switching The Isd300 On/Off - SEH ISD300 Kurzanleitung Zur Installation

Switching the ISD300 On/Off

Switching the Device On
Proceed as follows:
1. Switch on the power switch.
The ISD300 system software boots automatically if the device receives the
power it needs.
Switching the Device Off
Print jobs that are processed while the ISD shuts down cannot be completed.
Print jobs that are stored in a queue will be completed when the device reboots.
To avoid loss of data, shutdown the system software before you switch off the
power switch.
Proceed as follows:
1. Keep the soft power switch
The system software shuts down.
2. Switch on the power switch.
The device is shut down.
Booting/Shutting down the System Software
The system software can be booted/shut down manually.
Make sure that:
- The power switch is switched on.
To boot the software, press the soft power switch for a
To shut down the software, keep the soft power switch pressed for
seconds.
What Happens in the Case of a Power Failure?
When the ISD receives again the necessary power, it takes on the same status as
before the power failure.
10
pressed for five seconds.
[en]
short moment.
five
Quick Installation Guide