Parkside PPS 40 A1 Bedienungs- Und Sicherheitshinweise Und Originalbetriebsanleitung Seite 17

• Troubleshooting
Faults
Indicator lamp
does not lit up?
Ventilator does
not work?
Warning lamp
switches on?
No output
current?
Output current
does not
decrease?
Air current cannot
be regulated?
HF-arc is not
created?
Bad ignition?
Pistol is not ready
for operation
Cause of fault
No electrical connection
„
ON/OFF switch set to off
„
Power line interrupted
„
Power line ventilator faulty
„
Ventilator faulty
„
Overheating protection
„
switched on
Input voltage too high
„
Machine faulty
„
Overvoltage protection
„
activated
Input voltage too low
„
Connection cable cross-section
„
too low
Compressed air hose
„
damaged or faulty
Valve/manometer fails
„
The burner switch is faulty
„
Soldering point on the burner
„
switch or plug loosened
Valve/manometer fails
„
Burner wear parts damaged
„
or worn
Check HF spark gap
„
Current switch is switched off
„
Air transmission is restricted
„
Workpiece is not connected to
„
the ground terminal.
Troubleshooting
Troubleshooting
Check power cable
„
Set switch to ON
„
Check power line
„
Allow device to cool down
„
Input voltage according
„
to type plate
Machine must be repaired
„
Allow device to cool down
„
Observe input voltage
„
according to type plate
New connection of the hose
„
Renew electrode
„
Change wear parts
„
Set spark gap
„
Switch the current switch to
„
'on'
Another indication of this is
„
a green flame. Check the air
supply.
Check the connection.
„
GB/MT 77