Parkside PPS 40 A1 Bedienungs- Und Sicherheitshinweise Und Originalbetriebsanleitung Seite 9

WARNING!
f RISK OF SERIOUS
INJURY OR DEATH
FOR INFANTS AND
CHILDREN!
Never leave children
unsupervised near packaging
material. There is a risk of
suffocation.
This device may be used by
„
children aged 16 years and
older, and by persons with
reduced physical, sensory
or mental capacities, or a lack
of experience and knowledge,
if they are supervised or have
been instructed on how to
use the device safely and
understand the dangers that
may arise when using it.
Do not allow children to play
with the device. Cleaning and
day-to-day maintenance must
not be performed by children
without supervision.
Repairs and/or maintenance
„
work must only be carried
out by qualified electricians.
Only use the weld cable
„
provided in the scope of
delivery.
During operation, the device
„
should not be positioned
directly on the wall, covered
or jammed between other
devices so that sufficient air
can be absorbed through
the ventilation slats. Make
sure the device is correctly
connected to the supply
voltage. Avoid any form of
tensile stress of the power
cable. Disconnect the plug
from the socket prior to set-
ting up the device in another
location.
If the device is not in
„
operation, always switch it
off by pressing the ON/OFF
switch. Place the electrode
holder on an insulated surface
and only remove it from the
holder after allowing it to cool
down for 15 minutes.
Hot metal and sparks are blown
off from the cutting arch.
Flying sparks, hot metal as well
as hot objects and hot device
equipment can cause fires or
burns. Check the working
environment and make sure
the workplace is suitable prior
to using the device.
Remove all flammable materials
„
within 10 m of the plasma
cutter. If this is not possible,
cover the objects meticulously
using suitable covers.
Safety instructions
GB/MT 69