Parkside PPS 40 A1 Bedienungs- Und Sicherheitshinweise Und Originalbetriebsanleitung Seite 10

Safety instructions
Do not make cuts where flying
„
sparks could come into contact
with flammable material.
Protect yourself and others from
„
flying sparks and hot metal.
Please be careful because
„
sparks and hot materials can
easily fall through small gaps
and openings while cutting
and land on adjacent areas.
Please be aware that
„
cutting on a ceiling, floor
or a partition can cause
a fire on the opposite side
that is not visible.
Connect the cable as practical
„
as possible with a socket
situated close to the workplace
to prevent the power cable
from being spread across the
whole room and located on
unknown ground which could
cause an electric shock, sparks
or fire outbreak.
Do not use the plasma cutter
„
to defrost frozen tubes.
Risk of electric shock:
WARNING!
f Electric shock from the
welding electrode can
be fatal.
Do not use the plasma cutter
„
when it is raining or snowing.
70 GB/MT
Wear dry insulating gloves.
„
Do not touch the electrodes
„
with bare hands.
Do not wear wet or damaged
„
gloves.
Protect yourself from electric
„
shock with insulation against
the workpiece.
Do not open the device
„
housing.
Danger from welding
fumes:
Inhalation of welding fumes
„
can endanger health.
Do not keep your head in the
„
fumes.
Use the equipment in open
„
areas.
Use extractors to remove the
„
fumes.
Danger from welding
sparks:
Welding sparks can cause
„
an explosion or fire.
Keep flammable substances
„
away from the welding
location.
Do not use the plasma cutter
„
near flammable substances.
Welding sparks can cause fires.
„
Keep a fire extinguisher close
„
by and an observer should
be present to be able to use
it immediately.