Rules Of Use; Attachment The Tractor; Hooking; Floating Connecting Rod - maschio BRAVA LARGE Gebrauch Und Wartung

4.0 RULES OF USE

To obtain the best performance from the equipment, carefully
follow what is set up below.
ATTENTION
All maintenance work, adjustments and preparation for
operation, must be carried out with the power take-off of
the tractor disconnected, the machine on the ground on its
supporting feet, the tractor not running, the wheels blocked
and the key turned off.

4.1 ATTACHMENT THE TRACTOR

The machine may be attached to any tractor fi tted out with a
three-point universal joint.
The attachment to the tractor is a very dangerous phase.
Be sure to follow the instructions carefully throughout the
operation.

4.1.1 HOOKING

The correct tractor/machine position, is determined by placing
the equipment at a distance from the tractor so that the cardan
joint remains extended by 5-10 cm from its maximum closing
position. At this point, proceed as follows:
1) Hook the lifter bars onto the pins provided
Block with the snap split pins. Hook the chains to the lifting
bars
2) Connect the third upper point (2, fi g.11); the pin will be blo-
cked with the appropriate split pin; use the adjusting tie rod
(3, fi g.12) to keep the machine perpendicular to the ground
(fi g.12)
3) Block the movement of the parallels of the tractor on the
horizontal plane using the stabilizers provided, so eliminating
the side swaying of the equipment. Check that the tractor
hoisting arms are positioned at the same height from the
ground.
4) Adjust the height of the tractor lifting arms so that, in the
transporting position, the machine does not, for any
reason whatsoever, come into contact with the ground.
5) Connect the Cardan shaft and make sure that it is perfectly
blocked on the power take-off (fi g.13). Check that the guard
turns freely and fi x it with the chain provided.
During the work, regularly check that the equipment is
perpendicular.
ATTENTION: Always follow the indications recommended
by the Manufacturer for the transport of the machine.

4.1.2 FLOATING CONNECTING ROD

The fl oating connecting rod ensures that the machine follows
the contours of the ground during the working phase.(fi g.14)
ATTENTION
When fi tting the machine to the tractor work on a fl at sur-
face, adjust the working height, and keep the fl oating
connecting rod horizontally.
cod. F07021035
USE AND MAINTENANCE
DANGER
(1, fi g.11)
1
fi g.11
fi g.12
fi g.13
fi g.14
ITALIANO ENGLISH
2
1
3
LEVEL
A
EN - 51