RID14
5
Wiring
WARNING
!
Danger of explosion if unit is connected incorrectly in hazardous area
‣
When connecting Ex-approved devices please take special note of the instructions and
connection schematics in the Ex-specific supplement to these Operating Instructions. The
local E+H representative is available for assistance if required.
NOTICE
Electronics can be destroyed if unit is connected incorrectly
‣
Switch off power supply before installing or connecting the device. Failure to observe this
may result in destruction of parts of the electronics.
‣
The 4-pin post connector is only designed for connecting the associated display. Connecting
other devices can destroy parts of the electronics.
Devices can be connected to the FOUNDATION Fieldbus™ in two ways:
• Connection via conventional cable gland (→ ä 41)
• Connection via fieldbus connector (optional, can be purchased as an accessory) (→ ä 42)
5.1
Connecting the cable to the field indicator
For wiring a field indicator, proceed as follows:
3.
2.
Fig. 5: Opening the housing of the field indicator
1.
Open the cable entry.
2.
Remove cover clamp.
3.
Remove housing cover.
4.
Remove display.
5.
Remove screws from electronics unit.
6.
Remove electronics unit.
7.
Feed cables through cable entry.
Endress+Hauser
5.
1.
5.
4.
6.
Wiring
a0012568
39