Certificates And Approvals; Registered Trademarks; Installation; Incoming Acceptance, Transport, Storage - Endress+Hauser RID14 Anleitung

RID14
3.3

Certificates and approvals

CE mark, declaration of conformity
The field indicator is designed to meet state-of-the-art safety requirements, has been tested and
left the factory in a condition in which it is safe to operate.
The device meets the relevant standards and directives as per EN 61 010 "Safety requirements
for electrical equipment for measurement, control and laboratory use".
The device described in these Operating Instructions thus meets the legal requirements of the
EU directives. The manufacturer confirms that the device has been tested successfully by
affixing the CE mark.
CSA General Purpose.
3.3.1 Certification Foundation Fieldbus™
The field indicator has successfully passed all the tests and is certified and registered by the
Fieldbus Foundation. The device meets all the requirements of the following specifications:
• Certified in accordance with FOUNDATION Fieldbus™ specification
• FOUNDATION Fieldbus™ H1
• Interoperability Test Kit (ITK), revision status 5.1.0 (device certification number available on
request): the device may also be operated using certified devices from other manufacturers
• Physical Layer Conformance Test of the Fieldbus FOUNDATION™ (FF-830 FS 1.0)
3.4

Registered trademarks

FOUNDATION Fieldbus
Registered trademark of the Fieldbus Foundation Austin, Texas, USA
4

Installation

4.1

Incoming acceptance, transport, storage

The permitted ambient and storage conditions must be observed. The precise specifications can
be found in Section "Technical data".

4.1.1 Incoming acceptance

On receipt of the goods, check the following points:
• Are the packaging or contents damaged?
• Is anything missing from the delivery? Compare the scope of delivery with the information
you specified in the order. See also section 2.2 "Scope of delivery".
Endress+Hauser
TM
Installation
35