NOTE
►
The battery pack is supplied partially charged .
Before first use, charge the battery pack in
the charger for at least 1 hour . This guarantees
full battery power . You can charge the lithium-
ion battery at any time without shortening
its service life . Interrupting the charging
process does not damage the batterybattery
pack .
►
If the battery pack overheats during opera-
tion, charging is not possible . Allow it to cool
down first .
■
Never charge the battery pack
temperature is below 10°C or above 40°C .
1 . To remove the battery pack
button
and pull the battery pack
appliance .
2 . Insert the battery pack
charger
.
3 . Insert the mains plug into the socket . The control
LED
lights up red .
4 . The green charge status indicator LED
cates that the charging process is complete and
the battery pack
5 . Insert the battery pack
Use
Fitting/changing the saw blade
WARNING!
►
Wear protective gloves! There is a risk of
injury from the sharp cutting teeth .
►
Always remove the battery pack before car-
rying out any work on the appliance .
♦
Remove the blade guard
♦
Turn the quick-release chuck
this position .
♦
Push the required saw blade into the quick-
release chuck
as far as the stop .
■
8
│
GB │ IE │ NI │ CY
if the ambient
, press the release
out of the
into the high-speed
indi-
is ready .
back into the appliance .
.
and hold it in
♦
Let go of the quick-release chuck
returns to its initial position . The saw blade is
now locked .
♦
Check whether the saw blade is firmly fitted .
■
ATTENTION! The saw blade teeth must face the
front (see fold-out page)!
♦
Replace the blade guard
Fitting the rip fence
The rip fence
can be fitted on the left or right of
the appliance .
♦
Undo both of the clamping screws on the inser-
tion openings
.
♦
Push the rip fence
.
♦
Retighten the two locking screws .
Connecting the sawdust extractor
♦
Push the reducer
until it is firmly in place .
♦
Attach an approved dust and sawdust extractor
to the reducer
or directly to the extraction
nozzle
.
Fitting the splinter guard
The splinter guard
can prevent the surface from
tearing up when sawing wood . The splinter guard
can only be used with certain sawblade types
and only at a cutting angle of 0° .
♦
Press the splinter guard
from below (arrow pointing upwards) .
The ▲ marking on the splinter guard
towards the front of the appliance (see also fig . 1) .
Fig. 1: Fitting the splinter guard
so that it
on the appliance .
into the insertion openings
into the extraction nozzle
into the footplate
points
PSTKA 12 A1