Cablecom digital tv Bedienungsanleitung Seite 279

Resetting the Recorder
If you have problems with the recorder and
you do not know how to deal with them,
you may try resetting it to factory settings.
After that, your recorder will behave as it did
when you first switched it on. Bear in mind
that factory reset destroys your personal
information, such as channels, channel lists,
customized settings etc.
Go to Main Menu → settings → instal-
1.
lation → maintenance → factory
reset.
2. Press to change factory reset to
yes.
3. If you also want to clear the disk you should also change initialize hard disk
to yes. In this case, your recordings will be lost as well.
4. Press to start the process.
5. After a while, you will see the welcome screen. First-time installation will follow.
Refer to the "Installation" chapter.
You may also reset your recorder using the front panel. There are three methods:
• Soft reset – restarts the recorder but does not remove your favorite lists,
settings etc. To initiate it, press
buttons under the flap) and hold them for 5 seconds. When you release the
buttons, the recorder restarts.
• Factory reset – the same as factory reset in the Menu. To initiate it, press
and simultaneously (you'll find the buttons under the flap) and hold them for
5 seconds. When you release the buttons, the recorder restarts and first-time
installation follows.
Factory reset and hard disk initialisation – the same as factory reset in the
•
Menu. To initiate it, press
under the flap) and hold them for 5 seconds. When you release the buttons,
the recorder restarts, the disk is cleared of all recordings and first-time instal-
lation follows.
and simultaneously (you'll find the
and simultaneously (you'll find the buttons
Factory Reset
UserInstructions