Cablecom digital tv Bedienungsanleitung Seite 276

The stand-by indicator
on the front panel is
red.
Your remote control
fails to operate your
recorder.
Audio and Video Issues
Symptom
The picture on your TV
screen changes color.
This may happen after
a power-cut or after
your recorder has been
disconnected from the
power source.
Blocks appear in the
picture on the screen.
Your TV screen is
blank.
"Snow" appears on
your TV screen.

UserInstructions
Your recorder is in stand-by, press the
trol or button on the front panel.
• Check the batteries in your remote control.
• Make sure your recorder is in the operating mode.
• Make sure that you are pointing your remote control at the front
panel.
• Make sure that there is no direct sunlight from behind your
recorder.
• There may be a temporary transmission error, or your recorder
has lost some of its software settings. Switch it off and on again
after a few seconds.
Remedy
Your recorder has lost some of its software settings. Switch your
recorder off and on again after a few seconds. If the problem persists,
contact your vendor.
The signal is too weak or defective due to e.g. bad weather conditions.
• If your recorder is in stand-by, press the
remote control or
only if your TV set is in the AV mode).
• Check that your recorder is connected to the power source and
properly connected to your TV set.
• Disconnect and then reconnect your recorder.
• Your recorder is in stand by. Press the
control or
• Some of the connections to your recorder may have got loose.
Check that your recorder is connected to the power source and
correctly connected to your TV set.
key on your remote con-
key on your
button on the front panel (applies
key on your remote
button on the front panel.