Software Upgrade - Cablecom digital tv Bedienungsanleitung

Why is Stand-by Important?
The stand-by mode is indicated by the red light on the front panel. It is important
not to leave the recorder switched on but turned to stand-by due to a few reasons:
• Your recorder consumes much less electricity.
• The recorder looks for updates (see the "Other Functions" chapter). This ap-
plies to the device itself, channel lists and the contents of the tv guide.

Software upgrade

Please be aware that the software of your recorder may be automatically updated
from time to time, which may change the functionality of your recorder. Automatic
search for upgrade is performed, when the recorder is in stand-by mode. There-
fore, it is advised to switch your recorder to stand-by mode every time you stop
using it. For more on upgrades, see "Upgrading the Recorder" in "Other Func-
tions".
When the upgrade is in progress, do not power off your recorder until the upgrade
is complete.
Scrambled Channels and Smart Cards
The recorder supports reception of scram-
bled channels. However, it is possible to
watch such channels, record them and
make reservations only if you use a smart
card.
The Smart Card has to be inserted into
the slot on the front panel. Push the card
gently into a slot: the chip should face
downwards and the symbol of an arrow should point inwards.
The card is fragile, so keep in mind the following precautions:
• Do not bend or twist the card.
• Do not expose the card to heat or sunlight.
• After inserting the card, leave it in the slot permanently.
• Clean only with a soft dry tissue.

UserInstructions