Automatic Scan; Manual Scan - Cablecom digital tv Bedienungsanleitung

• If you enter an invalid setup-ID, you are prompted for its re-entry. How-
ever, after three unsuccessful attempts to enter your Setup-ID, you are
presented with the scanning method screen. This screen allows you
to select one of the two alternative scanning methods: automatic scan
or manual Scan.

Automatic Scan

If you select the automatic scan method,
your recorder scans the whole bandwidth for
any available networks. Once the recorder
completes this process, you are be prompt-
ed to select network. Then, this particular
network is scanned for any TV and radio
channels, and you are informed about the
total number of found channels.

Manual Scan

If you select the manual scan method,
you get access to the tuning parameters
screen. Type in correct values of tuning
parameters and then press
scanning procedure is initiated and you will be informed about the number of TV
and radio channels found.
In case of any problems, refer to the "Before Requesting Service" section in "Trou-
bleshooting" or try to disconnect and then reconnect cables.

UserInstructions
to confirm them. If the parameters are valid, the
Channel Search in Progress