First Time Installation - Cablecom digital tv Bedienungsanleitung

First Time Installation

When you have connected your recorder and other equipment properly, follow
these steps:
1. Turn your TV on.
2. Plug the power jack into the recorder and the power plug – into the power
socket. The Welcome screen should appear. If your recorder fails to operate,
check the connections first. Press
to leave this screen.
• If you use the SCART output of the
recorder, you will see the Welcome
screen on your TV screen.
• If you use the RF Cable output of
the recorder, you will have to tune
your TV set to the default RF channel
no. 43. For information, see your TV
manual. Alternatively, you can tune
your recorder to the channel that
your TV set is tuned to by executing
the procedure described below.
3. Next, a screen appears that allows you to select the on-screen language.
Highlight the desired language by pressing
choice with
4. A help screen follows. Read the provided information and press
5. Now, you have to provide the setup-ID. This 8-digit number is provided in
your contract and uniquely identifies your tuning parameters. Type in your
setup-ID with the number keys and
press .
• If you enter a valid setup-ID, the
channels search procedure is
initiated. Once this procedure
has been completed, you are
informed about the total number
of TV and radio channels that
have been found. Then press
to tune to the first TV chan-
nel found.
.
The Welcome Screen
/
, and confirm the
.
Setup ID
UserInstructions
1