Troubleshooting; Before Requesting Service - Cablecom digital tv Bedienungsanleitung

1 T roubleshooting

Before Requesting Service

Before requesting service for your recorder, please check the table below for a
possible cause of the problem you are experiencing. Some simple checks or a
minor adjustment on your behalf may eliminate the problem and restore proper op-
eration. The most common problems that arise are related to cable connections.
Make sure that your recorder is properly connected. To ensure that all the cables
are in their place, disconnect and connect them again. If none of the remedies
indicated in the table below solves the problem, consult your vendor.
Installation Issues
Symptom
Your recorder does not
find channels.
Nothing lights up on
the front panel.
General Issues
Symptom
The stand-by indicator
on the front panel does
not light up.
Remedy
• Make sure that the cable and antenna you are using are adequate
for digital signal reception.
• If you cannot resolve the problem easily you may need to have
your installation tested by a professional.
• Check if the power cable, SCART cable, antenna cable and plug
are correctly connected and the recorder is switched on. Discon-
nect these cables, and then reconnect them to ensure they are in
place.
• Check that power is available at the wall socket.
Remedy
• Check if the power cable, video cable and antenna cable are
correctly connected and the recorder is switched on. Discon-
nect these cables, and then reconnect them to ensure they are
in place.
• Check that power is available at the wall socket.

UserInstructions