Hitachi RCIM-1.0FSN4 Installations- Und Betriebshandbuch Seite 48

Installation of optional air panel: P-AP56NAM
17.6 TEST RUN
1 After completing the installation of the air panel, the test
run should be performed according to "Installation &
Maintenance Manual" of the indoor unit.
2 Perform the checking work for the louvre during the test run
(For PC-ARFPE). Do not move the louvre by hand. If moved,
the auto-swing mechanism will be damaged.
a. Press " " (run / stop), and the operation is started.
Select the air flow direction by " " or " ".
17.7 ADJUSTING LOUVRES
Procedures for Adjusting Louvres and Air Flow Direction
Step 1
Switch ON the main power source.
Step 2
Start the fan operation by pressing " " (run/stop) on the remote
control switch.
Step 3
Press " " or " " and select "
The auto swing operation is started, and is stopped by pressing
this switch again.
Step 4
LCD indication shows the position of the swing louvres.
< Auto swing operation >
< Fixed louvre angle >
38 PMML0363A rev.2 - 08/2016 - P5416559
" (auto swing).
The mark " " moves
continuously.
The mark " "
The mark " " indicates
indicates the position
the position of louvers.
of louvers.
b. The louvre angle is changed by pressing " " or " ".
LCD Indication
The auto swing operation will be started to select "
(auto swing). At this time, LCD indication displays the swing
repeatedly.
?
N O T E
• The adequate air flow direction may differ depending on the
conditions (air conditioner's installation position, room structure or
furniture layout, etc.) If the cooling or the heating is not well, adjust
the air flow direction.
• The position of the louvres may not coincide with the louvre position
indicator on LCD during the auto swing operation. When fixing the
louvre angle, set it according to the louvre position on LCD.
• Even if " " or " " is pressed to stop the auto swing, the louvre may
not be stopped soon.
• If the cooling operation is performed under the condition with over
80% humidity, dew condensation may occur at the air panel or the
louvre.
!
C A U T I O N
Do not move the louvre by hand. If moved, the louvre mechanism will be
damaged. In addition, do not apply an excessive force to the air outlet
part to prevent the breakage.
Louvre
Louver
"