Hitachi RCIM-1.0FSN4 Installations- Und Betriebshandbuch Seite 47

Installation of optional air panel: P-AP56NAM
17.5 ELECTRICAL WIRING
!
C A U T I O N
• Perform securely the electrical wiring work. If the electrical work is not completed, heat generation at the connection, a fire or an electric shock
may occur.
• Make sure that the wires are securely fixed in order not to apply an external force to the terminal connections of the wirings. If fixing is not
completed, heat generation or a fire will occur.
1 The following connectors are used in the air panel. Remove the tape fixing the wiring connectors on the air panel and pull out
them as shown in the figure below. Connect them with the wiring connectors to CN17 in the electrical box as the following figure.
CN17
Connector
(CN17)
Air panel
?
N O T E
Before the electrical wiring work, turn OFF the power source. If the connectors are connected without turning OFF the power source, the auto swing
louvre can not activate.
2 After completing the wiring connection of the air panel, attach the air inlet grille. Perform the attaching work in the reverse
procedure of removing. Refer to item 3 of the section
at the air panel. The air inlet grille can be attached from any 4 directions by rotating it. When multiple indoor units are installed or
requested from a user, the air intake grille direction can be selected freely.
37 PMML0363A rev.2 - 08/2016 - P5416559
Electrical box
ON
1 2
Earth screw
PCB
"17.4 Installation".
Hole at air panel
Ⓐ Part
Supporting string
ON
1 2
Indoor unit
Wire clamp
Control cable
Remote control switch cable
Power source cable
Cable for auto swing motor
Hook the swivel of the supporting string at Ⓐ to the hole