Speed Setting - Scheppach Molda 5.0f Originalbetriebsanleitung

Figure K
Sanding tasks
For sanding operations tasks with the drum sanding
attachments (accessory, article no. 7930 3500 or
7930 3000), the curved moulding guard (supplied as
standard) is used as a cover. The curved moulding
fence plate is not required and should be removed.

Speed setting

Figure L
Note the maximum rotation speed specified on the
moulding tool and the sticker on the side of the
switch: "Optimum speed range for moulding tools
on spindle moulders."
Your spindle moulder is equipped with the speeds
3000/6000/8200 rpm.
- Open the cover on the rear side.
The electrical circuit to the motor is interrupted when
the cover is opened
- Undo the belt tensioning device
The belt is detensioned
Select speed
-
Undo the ball knob screw, set the required speed,
the corresponding display lamp (3000/6000/8200)
lights up on the switch housing. Tighten the ball knob
screw.
- Move the belt
Clamp the belt-tensioning device and close the
-
cover as per the regulations to remove the
electrical motor lock.
Maximum speed depending on the moulding tool diameter or moulding thickness
Mot. speed
Ø 200 Ø 180 Ø 160 Ø 140 Ø 120 Ø 100
9.000
6.000
3.000
120
1.800
120
14 18 30
28 45 70
120 120
120 120
Figure K
Figure L
Schnittgeschwindigkeit in Abhängigkeit von Werkzeugdurchmesser und Drehzahl
(n max. keinesfalls überschreiten)
Speed chart
450 59 66
420 55 62
400 52 59
380 50 56
350 46 51
320 42 47
300 39 44
280 37 41
250 37
220
200
180
160
140
Erhöhte
120
100
Rückschlaggefahr
80
60
50 100 120
120 120 120
120 120 120
120 120 120
71 82
Bruchgefahr,
66 77
63 73 84
erhöhte
60 70 80
55 64 73 82
Lärmbelästigung
50 59 67 75 84
47 55 63 71 79
44 51 59 66 73 82
39 46 52 59 65 73 79 85
35 40 46 52 58 65 70 75 81
37 42 47 52 59 63 68 73
37 42 47 53 57 61 66
38 42 47 50 54 59
37 41 44 48 51
35 38 41 44
34 37
-1
Frässpindeldrehzahl (min
Moulder Ø
Moulding
thickness /
cutting width
[mm]
79 84
71 75 85
63 67 75 84
55 59 66 73 88
47 50 57 63 75
39 42 47 52 63
33 38 42 50
31 38
)
Page 47