Residual Risks; Scope Of Delivery - Scheppach Molda 5.0f Originalbetriebsanleitung

 Only use the machine if it is in a technically fully functional state. Pay attention to the intended use, safety
and potential dangers and comply with the operating instructions! Immediately repair any malfunctions
that may affect safety, or have them repaired.
 The safety, working and maintenance instructions and the dimensions stipulated in the specifications
must be observed.
 The applicable regulations for the prevention of accidents and other generally recognized safety rules
must be observed.
 The machine may only be used, maintained or repaired by trained persons who are familiar with the
machine and have been instructed about the dangers. The manufacturer shall not be liable for any
damage resulting from unauthorized modifications of the machine.
 The machine may only be used with original accessories of the manufacturer.
 Any other use is considered to be not intended. The manufacturer shall not be liable for any damages that
may result from such use. Such risk is borne exclusively by the user.

Residual risks

The machine has been constructed according to current technical standards and recognised safety rules.
Nevertheless, single residual risks may occur during operation.
 The rotating cutting tool may cause injury to fingers and hands if the workpiece is not guided in the proper
manner.
 Injury may be caused by a spinning workpiece if you work using inadequate support or guidance, for
instance by working without a fence.
 Danger to health from sawdust or wood shavings.
 Always wear personal protection equipment as well as goggles and a dust mask. Use the suction device!
 Health hazard from excessive noise. The permissible noise level is exceeded when working with the
machine. Always wear personal protection equipment such as ear protection.
 Danger from electric current if incorrect electrical connecting cables are used.
 Only machine selected wood without flaws such as: knots, lateral cracks, surface cracks.
 Wood that contains flaws can pose a risk when worked.
 Risk of injury from defective cutting tools. Check the tools regularly to ensure they are intact.
 Additionally, non-obvious residual risks may exist in spite of all measures taken.
 Residual risks can be minimised by carefully observing the "Safety instructions" and the "Intended use"
as well as the entire operating instructions.

Scope of delivery

Molda 5.0f Spindle Moulder
Curved moulding guard complete
with suction connector
Moulding fence complete with
overhead roller guard assembly
Spindle bushing, 2 pcs
Spindle bushing, 2 pc.
Spindle bushings, 2 pc.
Spindle bushing, 1 pc.
Single-head wrenches, 1pc.
Allen key
Suction connector
Accessory bag
Operating instructions
Accessories: page 28
0,5 mm long
5 mm long
10 mm long
15 mm long
SW 41
SW10
Article no. 7231 0019
Article no. 7210 5000
Article no. 3301429011
Article no. 3301429010
Article no. 3301429009
Article no. 3301429008
Article no. 0108 9413
Article no.
Article no. 7500 3800
Page 35