Installation And Adjustment; Overhead Roller Guard Assembly; Curved Moulding Guard; ( Supplied As Standard ) - Scheppach Molda 5.0f Originalbetriebsanleitung

Installation and adjustment

Height compensation
Figure A
The machine is supported by four adjustable rubber
feet.
Compensating for uneven floors: undo the lower
hexagonal nuts using a spanner and screw the rubber
feet in or out as required.
Retighten the hexagonal nuts.
Caution!
Use a spirit level to align the machine.
If the rubber feet are removed, the machine can be
screwed to the floor via the threaded drill holes.
Overhead roller guard assembly (supplied as
standard)
Figure B
 Mount the overhead roller guard assembly at right
angles to the table plate using two knurled screws
and discs (1).
 Use the set screw (2) to adjust the overhead roller
guard assembly.
Figure C

Curved moulding guard

Bearing ring
Affix the curved moulding guard to the table plate using
two knurled screws and discs.
The bonded wood guide rail can be mounted on the
moulding table on both sides at a tangent to the
bearing ring. (M 8 x 45 hexagonal nut and disk Ø 8)
(optional)
Figure A
Figure B
Figure C
Figure D
1 2
Page 39