Setting The Material Volume; Maintenance; Operating The Air Paint Spray Gun; Preparing The Surface - Parkside PDLS 5 A1 Originalbetriebsanleitung

Switching on:
WARNING!
► The air vent on the suction cup mount and
must always be free.
► Always stop work immediately if compressed
air or spray material is discharged from
the air vent . Eliminate the cause before
continuing work.
► If you want to work in a position in which the
suction cup is being held at an angle, only
fill it half full. This ensures that no spray
material can get into the air vent
♦ To switch on, pull the trigger on the air spray
gun and keep it pressed in.
Switching off:
♦ To stop working, simply release the trigger on
the air spray gun

Setting the material volume

You can regulate the material quantity which is
sprayed.
♦ Undo the lock nut
♦ Turn the nozzle
♦ Fix the nozzle in place with the lock nut

Maintenance

WARNING! RISK OF INJURY! Discon-
nect the tool from the compressed air
supply.
♦ Clean the appliance after every use.
WARNING – PROPERTY DAMAGE!
► Never submerse the appliance completely in
cleansing agents, otherwise the seals can be
damaged.
♦ Rinse the air spray gun out using a container
filled with a suitable cleansing agent at low
pressure.
♦ Collect the liquid in a container and dispose of
the liquid in an environmentally correct manner.
♦ Oil the moving parts on the trigger of the air
spray gun .
PDLS 5 A1
.
.
.
into the required position.
Operating the air paint spray
gun

Preparing the surface

♦ Carefully cover a large area around the spray
surface. Any surface that is not masked could
become contaminated.
♦ Ensure that the surface is clean, dry and free of
grease.
♦ Polished surfaces should be lightly sanded and
the sanding dust removed.
Switching the air paint spray gun on
and off
Working methods:
♦ When thinning, ensure that the spray material
and the thinners are suitable for each other.
Using an unsuitable thinner can lead to the
formation of lumps which, in turn, can block the
air paint spray gun.
♦ Unscrew the lid
cup .
♦ Fill the aluminium suction cup
material.
.
♦ Screw the lid
suction cup
♦ With the aid of the fixing nut,
minium suction cup
spray gun in an anticlockwise direction.
♦ Hold the air paint spray gun at a constant
distance from the object. The ideal spraying
distance is approx. 15 cm.
♦ Work out the best settings by carrying out a
test.
♦ Do not switch the appliance on/off over the
spray surface, rather start/end the spraying
process approx. 10 cm from the spray surface.
from the aluminium suction
with the spray
back on to the aluminium
.
screw the alu-
tightly onto the air paint
GB │ IE │
19 ■