Safety Advice; Original Accessories / Attachments; Bringing Into Use; Connecting The Compressed Air Source - Parkside IAN 33355 Bedienungs- Und Sicherheitshinweise

Safety advice

WArnIng!
and instructions. Failure to observe the safety
advice and instructions could result in serious injury
and / or damage to property.
KEEP ALL THE SAFETY ADVICE AND INSTRUC-
TIONS IN A SAFE PLACE FOR FUTURE REFERENCE!
WArnIng!
TIOn! Working with nitrogen presents
a danger of suffocation! Work in well
ventilated spaces only.
WArnIng!
Never exceed the maximum allowable working
air pressure of 8 bar. Use a pressure reducer
to set the working air pressure.
WArnIng!
never point the device at people or
animals.
WArnIng!
Never use oxygen or other combustible gas as
the energy source.
WArnIng!
First disconnect the hose from the
compressed air source and only then
disconnect the compressed air supply
hose from the device. This will ensure that
the compressed air supply hose does not wave
around or recoil in an uncontrolled manner.
J
equipment.
J
you to lose control of the device.
J
Disconnect the device from the compressed air
source before carrying out any repairs or main-
tenance of the device or moving it to another
location.
J
When removing the hose coupling, hold the
hose tightly in your hand to avoid injury
caused by the hose shooting backwards.
Downloaded from www.Manualslib.com
read all the safety advice
DAngEr OF SUFFOCA-
DAngEr OF InJUrY!
DAngEr OF InJUrY!
DAngEr OF InJUrY!
DAngEr OF InJUrY!
For your own safety, wear
suitable personal protective
Keep children and other people
away while you are operating
the device. Distractions can cause
manuals search engine
Safety advice / Bringing into use
J
Look out for damage on the device.
Check the device for damage before bringing it
into use. Do not use the device if you discover
any defects.
J
Do not kink the device's hose, otherwise you
may damage it.
Original accessories /
Q
attachments
J
Use only the accessories and attach-
ments detailed in the operating in-
structions. The use of accessories other than
those recommended in the operating instructions
could lead to you being in danger of injury.

Bringing into use

Q
Connecting the
Q
compressed air source
nOTE: Operate the product only with cleaned, conden-
sate- and oil-free compressed air and never exceed the
maximum working air pressure at the device of 8 bar.
nOTE: The compressed air source must be fitted
with a (filter) / pressure reducer so that the air pres-
sure can be regulated.
j
Connect the product to a suitable compressed air
source by connecting the quick-release coupling
of the air supply hose with the plug-in nipple
the product. It locks itself in place automatically.

Using the tyre inflator gauge

Q
1. Place the valve connector
Schrader valve, car tyre valve
(e.g. often used on mountain bikes)
to
4
2
on to the valve.
5
GB 7