Electrical Connection; Connector S32/Cable Connection - Balluff BTL7-A serie Betriebsanleitung

BTL7-A/C/E/G50_-M_ _ _ _ -T_2/3-NEX-S32/KA_ _
Micropulse Transducer - Rod Style
4
Installation and connection (continued)
Magnet
(e.g. BTL-P-1028-15R)
Supporting rod made of non-magnetizable material
Fig. 4-8: Example 2, transducer installed with supporting rod
4.4.1

Connector S32/cable connection

S32
Pin Cable color
1 YE yellow
2 GY gray
3 PK pink
4 RD red
5 GN green 0...10 V
6 BU blue
7 BN brown
8 WH white
Tab. 4-2: Connection assignment BTL7-A/C/E/G504-...S32/cable
S32
Pin Cable color
1 YE yellow
2 GY gray
3 PK pink
4 RD red
5 GN green 10...0 V
6 BU blue
7 BN brown
8 WH white
Tab. 4-3: Connection assignment BTL7-A/C/E/G505-...S32/cable
1) Unassigned leads can be connected to the GND on the controller side but not to the shield.
2) Factory setting, can be freely configured with the PC software.
3) Reference potential for supply voltage and EMC-GND.
www.balluff.com
BTL7-... interface
-A504 -G504
Not used 1) 0...20 mA
0 V
Not used
La (communication line)
2) 10...10 V 2)
–
GND 3)
10...30 V
Lb (communication line)
BTL7-... interface
-A505 -G505
Not used 1) 20...0 mA
0 V
Not used
La (communication line)
2) 10... 10 V 2)
–
GND 3)
10...30 V
Lb (communication line)
4.4

Electrical connection

Depending on the model, the electrical connection is made
using a cable or a connector (BTL7-...-S32).
The connection or pin assignments for the respective
version can be found in Tables 4-2 to 4-3.
Note the information on shielding and cable
routing on page 14.
-C504 -E504
2) 4...20 mA 2)
Fig. 4-9:
1)
Not used 1)
-C505 -E505
2) 20...4 mA 2)
Fig. 4-10: Pin assignment of S32
1)
Not used 1)
Ignition protection
"nA" and "tb"
Pin assignment of S32
connector (view from above on
transducer), 8-pin M16 circular
plug
connector (view from above on
transducer), 8-pin M16 circular
plug
english 13