Function; Led Display - Balluff BTL7-A serie Betriebsanleitung

BTL7-A/C/E/G50_-M_ _ _ _ -T_2/3-NEX-S32/KA_ _
Micropulse Transducer - Rod Style
3
Construction and function (continued)
3.2

Function

The Micropulse Transducer contains the waveguide which
is protected by an outer stainless steel tube (rod). A
magnet is moved along the waveguide. This magnet is
connected to the system part whose position is to be
determined.
The magnet defines the position to be measured on the
waveguide.
An internally generated INIT pulse interacts with the
magnetic field of the magnet to generate a torsional wave
in the waveguide which propagates at ultrasonic speed.
The component of the torsional wave which arrives at the
end of the waveguide is absorbed in the damping zone to
prevent reflection. The component of the torsional wave
which arrives at the beginning of the waveguide is
converted by a coil into an electrical signal. The travel time
of the wave is used to calculate the position. Depending
on the version, this information is made available as a
voltage or current output with a rising or falling gradient.
Depending on the version, this output signal is therefore
redundantly present at 2 or 3 independent measuring
units.
One output is available per measuring unit. The following
functions can be selected for the output values:
– Position
– Velocity (with or without leading sign)
The entire function scope can only be
configured with the PC software "Micropulse
Configuration Tool". To do this, the USB
communication box must be connected (see
Accessories on page 20).
10 english
3.3

LED display

LED
Fig. 3-2: Position of the BTL7 LED displays
In normal operation, the LEDs indicate the
operating states of the measuring units.
LED Operating state
Normal function
Green
Magnet is within the limits.
Error
Red
No magnet or magnet outside the limits.
Tab. 3-1: LED displays in normal operation
Ignition protection
"nA" and "tb"