Operation; Before Use; Connecting - ULTIMATE SPEED ULGD 5.0 A1 Originalbetriebsanleitung

Ensure that there is no possibility of
■
ignition of explosive or flammable
substances, such as petrol or solvents,
while using charger!
Ensure that there is adequate venti-
■
lation during charging.
DANGER OF CHEMICAL
BURNS!
Wear protective glasses! Wear
■
protective gloves! If eyes or skin has
come into contact with battery acid,
rinse the affected body region off
with a large amount of clean water
and consult a doctor straight away!
Avoid causing a short circuit when
■
connecting the charger to the bat-
tery. Connect the negative pole
connector cable only to the nega-
tive battery or to the body work.
Connect the positive pole connector
cable only to the plus pole of the
battery!
Do not place the charger close to fire,
■
heat or to places with long-term expo-
sure to temperatures over 50 °C!
Ensure that no fuel lines,electric
■
cables, hydraulic or water pipes
are damaged by the screws during
assembly of the charger!
Do not cover the charger with any
■
objects!
Protect the electrical contact sur-
■
faces of the battery from short
circuiting!
■ 14 │ GB │ IE
Only use the charger for charging
■
and for charge retention of 6 V /
12 V lead batteries.
Do not charge frozen batteries.

Operation

Before use

♦ Before connecting the charger, the operating
instructions must be observed.
♦ Furthermore, the instructions of the vehicle man-
ufacturer regarding a permanently connected
vehicle battery must be observed. Secure the
vehicle, switch off the ignition.
♦ Clean the battery poles. Take care that while doing
so, your eyes do not come into contact with the dirt.
♦ Ensure sufficient ventilation.

Connecting

NOTES
► There are two options for connecting the
charger. Connect the negative terminal
connecting cable (black) either directly to
the negative terminal of the battery or to
the bodywork. Please also bear in mind the
vehicle manufacturer's instructions.
♦ Before starting the charging or trickle charging
procedure on a permanently installed battery in
a vehicle, first disconnect the negative terminal
connecting cable (black) of the vehicle from the
negative terminal of the battery. The negative
terminal of the battery is usually connected to
the vehicle's coachwork.
♦ Connect the positive pole clamp (red)
charger to the positive pole of the battery.
♦ Connect the negative pole clamp (black)
negative pole of the battery or to the bodywork.
♦ Connect the mains cable
the mains socket.
♦ The battery voltage display
rent battery voltage.
♦ Should the connection of the clamps be swapped,
the LED „reverse connection"
of the
to the
of the charger to
shows the cur-
lights up.
ULGD 5.0 A1