Additional Safety Instructions; Danger Of Electric Shock - ULTIMATE SPEED ULGD 5.0 A1 Originalbetriebsanleitung

This appliance may be used by chil-
■
dren aged 8 over and by persons
with reduced physical, sensory or
mental capabilities or lack of expe-
rience and knowledge, provided
that they are under supervision
or have been told how to use the
appliance safely and are aware of
the potential risks. Children must not
use the appliance as a plaything.
Cleaning and user maintenance
tasks may not be carried out by
children unless they are supervised.
If the supply cord is damaged, it must
■
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.

Additional safety instructions

Do not use the charger for charging
■
non-rechargeable batteries.
Do not use the charger for charging
■
lithium-ion batteries.
Place the removed battery in a well-
■
ventilated location during charging.
The automatic mode of operation
■
and usage restrictions are explained
below in these operating instruc-
tions.

DANGER OF ELECTRIC SHOCK!

Do not operate the appliance with
■
a damaged cable, supply cord or
mains plug. A damaged power cord
causes danger to life by electric shock.
ULGD 5.0 A1
Before connecting to the power,
■
ensure that the power connection is
earthed, is 230 V ∼, 50 Hz, and is
16 A fused and equipped with an
RCCB switch (residual current circuit
breaker) in accordance with the cur-
rent regulations!
Disconnect the charger from the grid,
■
before you make or break connec-
tions to the battery.
Always connect the positive terminal
■
clamp (red)
The negative terminal clamp (black)
■
must be connected to the chassis at
least 10 cm away from the battery
and the fuel line.
Now connect the charger to the
■
power supply.
After charging, disconnect the
■
charger from the grid. Only after this
remove the clamp from the bodywork.
Following this, remove the clamp
from the battery.
DANGER OF EXPLOSION
AND FIRE HAZARD!
Protect yourself from a highly explo-
sive hydrogen-oxygen reaction!
Ensure that during charge and
■
charge retention procedures, there
are no naked lights (flames, cinders
or sparks)!
Ensure that the plus cable does not
■
come into contact with fuel lines
(e.g. petrol pipe)!
first.
GB │ IE │ 13 ■