Cleaning The Air Filter - Ryobi Rbl42Bp Bedienungsanleitung

warm. It is reported that cold weather is a major factor
contributing to Raynaud's Syndrome.
■ After each period of operation, exercise to increase
blood circulation.
■ Take frequent work breaks. Limit the amount of
exposure per day.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your physician.
WARNING
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged
periods, ensure you take regular breaks.
MAINTENANCE
WARNING
Use only original manufacturer's replacement parts,
accessories, and attachments. Failure to do so can
cause possible injury and poor performance, and may
void your warranty.
WARNING
Servicing requires extreme care and knowledge
and should be performed only by a qualifi ed service
technician. For service, bring the product to an
authorised service centre. When servicing, use only
original replacement parts.
■ Stop the engine, allow the product to cool down, and
make sure all moving parts have come to a complete
stop. Disconnect the spark plug boot before conducting
any maintenance or cleaning work.
■ You may make adjustments and repairs described in
this manual. For other repairs, contact an authorised
service centre.
■ After each use, clean the product with a soft, dry cloth.
■ Check all nuts, bolts, and screws at frequent intervals
for proper tightness to ensure that the product is in safe
working condition. Any part that is damaged should be
properly repaired or replaced by an authorised service
centre.
■ Bring the product to an authorised service centre to
replace damaged or unreadable labels.
CLEARING A BLOCKAGE
■ To reduce the risk of injury associated with contacting
rotating parts, always stop the engine, and make sure
English (Original instructions)
■ Remove the blower tubes to inspect for blockage.
■ Reinstall the blower tubes before starting the product.

CLEANING THE AIR FILTER

See Fig. 6.
A wet or dirty air fi lter causes starting diffi culty, loss of
performance, and shorten the life span of the engine. The
air fi lter should be checked and cleaned after 5 hours of
operation. Inspect and clean more frequently if used in
dusty dirty conditions.
For best performance, the air fi lter should be replaced
yearly.
To clean the air filter:
1. Press the air fi lter cover tab to open the air fi lter cover.
2. Remove the cover.
3. Lift the edge of the air fi lter carefully and peel it out.
4. Wash the air fi lter with warm, soapy water.
5. Rinse and squeeze to dry.
6. To reinstall the air fi lter cover, insert the tabs into the
CLEANING THE EXHAUST PORT, MUFFLER, AND
SPARK ARRESTOR
NOTE: Depending on the type of fuel used, the type
and amount of lubricant used, and/or your operating
conditions, the exhaust port, muffl er, and/or spark arrestor
screen may become blocked with carbon deposits.
If you notice a power loss with your petrol-powered
product, you may need to remove these deposits to
restore performance. We highly recommend that only
qualifi ed service technicians perform this service.
The spark arrestor must be cleaned or replaced every 50
hours or yearly to ensure proper performance of your product.
Spark arrestors may be in different locations depending on
the model purchased. Please contact your nearest service
dealer for the location of the spark arrestor for your model.
To avoid a fi re hazard, never run the blower without the
spark arrestor in place.
14
all moving parts have come to a complete stop.
Clear the tubes if required.
notches and lock into place.
NOTE: Make sure the fi lter is seated properly inside the
cover. Installing the fi lter incorrectly will allow dirt to enter
the engine, causing rapid engine wear.
WARNING