MSAC501
26
Accessory connector
NOTICE
3. Strip cable, shorten and enlarge the shield.
4. Solder strands (see chapter 4.3) to contact insert
connection diagram.
5. Mount parts
...
2
6. Screw pressing screw
Fig. 3: Straight mating connector M12
9.2 Mating connector M12 straight inclusive cable
• Accessory SIKO art. no. "KV12S2" (socket contact 12 pin).
9.3 Right angle mating connector M12
Advice
` Strand cross sections of lines max. 0.25 mm² / cable feed-through: ø6
- ø8 mm.
• Accessory SIKO art. no. "85278" M12 A coded (socket contact 12 pin).
Mounting
(Fig.
4)
1. Mount seal to shielding ring
2. Slip parts
...
1
3. Strip cable, shorten and enlarge the shield.
4. Push insulating sleeve
5. Push the strands through the housing
shielding ring
4
6. Push seal
into pinch ring
3
screw
and screw housing
1
7. Solder strands (see chapter 4.3) to contact insert
connection diagram.
MSAC501 · Date 30.04.2018 · Art. No. 88113 · Mod. status 167/18
. Place shield around shielding ring
6
on coupling sleeve
1
.
4
over outer cable.
4
into housing
6
and insert in housing
and slide both parts into pressing
2
together.
5
according to
7
4
.
5
.
5
. Tilt the shield around
5
.
5
according to
7
English
.