Multitab Function; Setting And Starting A Washing Programme - Electrolux GA55LV101 Benutzerinformation

Multitab function

The multitab function is for combi detergent
tablets.
These tablets contain agents such as deter-
gent, rinse aid and dishwasher salt. Some
types of tablets can contain other agents.
Do a check if these tablets are applicable for
the local water hardness. Refer to the in-
structions from the manufacturer.
When you set the multitab function, it stays
on until you deactivate it.
The multitab function stops automatically the
flow of rinse aid and salt. The salt indicator
light is deactivated.
The programme duration can increase if you
use the multitab function.
Activate or deactivate the multitab func-
tion before the start of a washing pro-
gramme.
You cannot activate or deactivate the
multitab function when the programme
operates. Cancel the washing pro-
gramme, then set the programme again.
To activate the multitab function:
• Press and hold the two multitab buttons
(function buttons D and E). The multitab
indicator light comes on.
To deactivate the multitab function:
• Press and hold the two multitab buttons
(function buttons D and E). The multitab
indicator light goes off.
Do these steps if the drying results
are not satisfactory:
1. Fill the rinse aid dispenser with rinse
aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.

Setting and starting a washing programme

Set the washing programme with the
door ajar. The washing programme
starts only after you close the door. Until
then it is possible to modify the settings.
Do these steps to set and start a washing
programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
• You can only activate or deactivate
the rinse aid dispenser when the mul-
titab function is activated.
To activate the rinse aid dispenser
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C.
– The indicator lights for function buttons
A, B, and C start to flash.
4. Press function button B.
– The indicator lights for function buttons
A and C go off.
– The indicator light for function button B
continues to flash.
5. Press function button B again.
– The end-of-programme indicator light
comes on.
6. Switch off the appliance to save the op-
eration.
To deactivate the rinse aid dispenser do the
above steps until the end-of-programme in-
dicator light goes off.
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid
dispenser.
3. Adjust the water hardness setting to
the highest level.
4. Do a washing programme without
dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the rinse aid dosage.
3. Press one of the programme buttons.
Refer to the chapter 'Washing pro-
grammes'.
– The programme indicator light comes
on.
– The digital display shows three hori-
zontal bars.
4. Close the door.
– The washing programme starts auto-
matically.
electrolux 81