Forming Machine Start-Up And Use; Start-Up Phase - CombiSteel 7485.0200 Gebrauchsanweisung

3 FORMING MACHINE START-UP AND USE

COMMAND PANEL DESCRIPTION
Legend:
A = Main switch
B = Lower plate thermostat
C = Upper plate thermostat
D = Timer stops in the compression phase
E = Green START buttons
The panel consists of a main switch (A), 2 thermostats (B - C), a timer (D), a green START buttons (E).
The panel permits start-up and stopping of the pizza shaping machine, and regulates functioning and settings.

START-UP PHASE

Connect the forming machine to the electrical mains and turn the main switch A to the position "1".
Adjust thermostats B and C of the plates to 150° C
Programme timer D to 0.6-1 seconds.
Push the green buttons START (E).
If the first start the bottom plate is not lifted completely, but rises only about 2 cm, the phase sequence is not
correct. Reverse 2 phases on the power plug.
Turn the machine on, after about 15 minutes execute a few no load starts and check that both the heating of
the discs and overall operation is normal.
REGULATIONS
Regulating the machine can only be recommended as there are different characteristics of: the dough, the weight,
the thickness, the size and the shape of the disk. Therefore the correct regulating of the machine must be made
by experimenting.
5
www.combisteel.com