CombiSteel 7485.0200 Gebrauchsanweisung Seite 6

How to regulate the thickness
The machine is provided with a medium (about 1 mm) size regulation for the shapes of pizza. With this machine
you can have different thicknesses of dough to suit all requirements by just turning the regulating knob F as
showed on the lower label:
- (-) turning anticlockwise for minimum thickness
- (+) turning clockwise for maximum thickness.
WORKING PHASE
Prior to starting each work cycle, make sure that the machine is perfectly clean, especially the surface of the
plates, the protections and any surface in contact with food products.
After turning on the machine, program the timer D from 0 to 1.5 seconds and set the thermostats B and C to
values between +150°C and +160°C.
The electric heating elements, located inside the discs, are turned on simultaneously which, due to the heat
effect, start the disc heating phase and the temperature is maintained constant at the values set with the
thermostats.
DANGER
It is absolutely forbidden to put your hands inside the discs while the machine is running. In addition, the discs
and the adjacent surfaces get extremely hot and can become a hazard for burning. Hence it is essential to pay
maximum attention, avoid contact with the parts mentioned, follow the instructions for use.
Once the discs have become thermally stable (the waiting time for this varies according to the temperature set)
the working phase can be started.
Using a suitable spatula which you have floured slightly, take a ball of dough (that has already been left to rise
for at least 4 - 6 hours) and place it in the middle of the bottom disc.
Close the protection to start the raise and lower cycle of the lower disk.
The length of time for which the discs are compressed, necessary to form the dough, is set on timer D according
to the value set previously.
At the end of compression the bottom disc moves down to the initial home position. At the end of the cycle the
dough will have become flat and circular, ready to be taken with the spatula.
! If, during the working phase, it is necessary to interrupt the ascent of the bottom disc and move it back into
the home position, open the protection and press push button E.
! Before proceeding with working phases, check the status of the various safety devices. These are in a good state
when:
- the machine stops when the front protection is lifted;
- the machine does not start when the rear protection is lifted or removed.
SHUT-DOWN PHASE
To shut down the forming machine turn the main switch knob A or the position "0".
www.combisteel.com
6