Installation - CombiSteel 7485.0200 Gebrauchsanweisung

2 INSTALLATION

Installation must be executed by qualified personnel in compliance with local, national and European regulations.
FORMING MACHINE LEVELLING
If the machine is unstable due to floor irregularity, adjust the support feet by inserting rubber pieces.
EQUIPMENT HOOK-UP
It is sufficient to connect the power supply cable to the electrical mains power supply.
The electrical outlet must be easy to access, no moving should be necessary.
The electrical connection (plug) must be easily accessible, also following forming machine installation.
The distance between the machine and the socket must be adequate to not cause tension in the power supply
cable. In addition, the cable must not be located beneath the machine support feet or wheel.
If the electrical power supply cable is damaged, it must be replaced by the technical assistance service or by a
qualified technician to prevent any risks.
GROUND CONNECTION
DANGER
It is mandatory that the electrical system is equipped with a ground connection and differential switch that
comply with currently enforced laws.
FORMING MACHINES 230V MONOPHASES
to overcome the phenomenon producing temporary current sudden changes and in presence of speed variator
(inverter), fit on the machine, it is necessary that the electric installation is equipped with a Class A differential
switch super immunized, type "SI", guaranteeing the continuous availability of the electric current under full
security.
4
www.combisteel.com