Network Management Card (Optional) - PowerWalker VI 1000 ERT HID Bedienungsanleitung

Warning:
This circuit must be separated from hazardous voltage circuits by
EN
reinforced insulation.
Caution:
The EPO must not be connected to any utility connected circuits.
Reinforced insulation to the utility is required. The EPO Switch must have
a minimum rating of 24Vdc and 20mA and be a dedicated latching-type
switch not tied into any other circuit. The EPO signal must remain active
for at least 20ms for proper operation
Wire Function
EPO
Note: Leave the green EPO connector installed in the EPO port of the UPS
even if the EPO function is not need. Remove the small cable from EPO
connector.

5.3 Network Management Card (Optional)

Network Management Card allows the UPS to communicate in a variety of
networking environments and with different types of devices. The series UPS has
one available communication slot for Webpower or other optional card to achieve
remote management of the UPS through internet/ intranet. Please contact your
local dealer for further information.
EPO Connections
Terminal Wire Size Rating
2
4-0.32mm (12-22AWG)
EPO Connector
25
Suggested Wire Size
2
0.82mm (18AWG)