Wall-Mounting Instructions (Optional) - PowerWalker DC UVS Bedienungsanleitung

4.2 Wall-Mounting Instructions (Optional)

NOTE: Required hardware not included. Refer to the wall-mount instructions
for required tools and materials.
EN
STEP 1: Make a mark on the wall in the 2 screw locations. The distance
between the centers of the 2 screws are 80cm.
STEP 2: Use a drill to drill holes where you made the mark on the wall. If you
drill into a wall stud, proceed to Step 5. If not, go to Step 4.
STEP 3: Insert anchor(s) into the hole(s).
STEP 4: Screw in the screw, leaving it protruding 1⁄4 inch from the wall.
STEP 5: Mount the DC UPS on the screw heads. Mounting holes
Page 9