Jacuzzi J-470 Montageanweisung Und Bedienung Und Wartung Seite 83

J-1000 REMOTE CONTROL
Most parts of the functions can be managed through this re-
mote control whose main characteristics are:
- when turning on, the remote control will check the correct
communication with the spa control unit; a control procedure
that individuates the various active functions (that are indica-
ted on the remote control display itself) will start. The water
temperature and the main menu are also shown.
- if the remote control remains unused for a period of ap-
proximately 15 seconds it will be turned off automatically;
press any button to reactivate the remote control (the display
and the keypad will light up).
Note: the remote control is water resistant (but not water ti-
ght); store in a dry place when not in use . Do not leave in the
spa underneath the cover.
1
Symbols legend
indicates that the spa functions are blocked (may be un-
blocked via the control panel only).
Temperature setting.
Time setting
Heating
1
Lighting system.
U S B
iPod
AUX
1
1 2
3
1
light colour cycle.
2
function not available.
2
function not available.
1
Pump 1
2
Pump 2
3
Pump 3
flat battery
AM
AM frequency (radio mode).
FM
FM frequency (radio mode).
radio mode
CD mode.
U S B
USB mode (check that the device is attached).
NAND mode (internal memory).
N A N D
AUX mode (check that the device is attached).
AUX
iPod
iPod mode.
"Return" key
UP
LEFT RIGHT
multifunction keypad
DOWN
Establish a connection between the remote control and
the spa
The first time the remote control is used it must be configured
to dialogue with the spa control unit.
I
Keep the D key and the lower zone of the circular keypad pres-
sed down contemporaneously for about 2 seconds: the confi-
guration instructions will appear on the display.
REMOTE CONTROL
CONNECTION
Press the keys below
Return, up
Return, up
Return, up
Select
I
Press the following keys on the remote in the sequence in-
dicated:
• return, upper zone of the multifunction keypad
• return, upper zone of the multifunction keypad
• return, upper zone of the multifunction keypad
• central key of the multifunction keypad
I
The screen on the left will appear first on the control pa-
nel followed by the next screen: at this point the configuration
is completed (press any key on the panel to return to the ope-
rative menu).
83
D