2. How to use
Reset
1
2
+
Press + hold!
3
Reset
completed
As soon as you open the hot water tap, the instantaneous water heater switches
on auto matically. When the tap is closed, the appliance automatically switches
off.
Temperature setting
• You can set the required temperature gradually to a lower or higher value with the
arrow keys
and
. The temperature changes by 1 °C if key is pressed shortly one
time. Pressing a key for a longer time changes the temperature continuously. You
can select the outlet temperature in a range from 20 °C to 60 °C.
Note: If temperature is set below 20 °C with arrow key
and the appliance switches off the heating function.
Note: If the water heater supplies a shower, the maximum temperature was
reduced during initial operation. This limitation cannot be exceeded.
Programme buttons
The two programme buttons
When pressing a programme key, the preset temperature is selected and displayed.
The factory setting for programme
assign your own settings for the programme keys:
• Prolonged pressing of the programme key stores the previously selected tem
perature. The display changes from "P1" or "P2" to the newly stored temperature
value. This newly set temperature is now available to you each time you press the
corresponding program key.
Temperature limitation
The instantaneous water heater DIS is equipped with an optional temperature limiting
function. This scalding protection is deactivated in the factory setting.
• Switch on: Select the limit tempe ra ture, then press
least 3 sec. The dis play briefly confirms the activation by "HI".
• Switch off: press program key
play briefly confirms the deactivation by "--".
Note: By activation of the temperature limit also the programme keys are limited.
Therefore, the fixed values of the programme keys may be set again after deacti
vation of the temperature limitation.
Reset to factory setting
All factory settings can be recalled:
• Press
and
simultaneously. The display now counts backwards from "10" to
"00" in second intervals. The appliance is reset at value "00" if you stop pressing
the keys earlier, you will cancel the process.
7
the display shows "--"
and
allow to quickly select the preset temperature.
is 35 °C and for programme
and
and
simultaneously for at least 3 sec. The dis
CLAGE
EN
it is 48 °C. You can
simul taneously for at